|Rocky Mountain Section - 59th Annual Meeting (7–9 May 2007)|
|Paper No. 16-7|
|Presentation Time: 8:00 AM-12:00 PM|
PHYSICAL ANALOG MODELS OF BASEMENT FAULT SEGMENTATION AND MONOCLINAL FOLDING
JENESKY, Timothy A., Department of Physical Sciences, Kutztown Univ, Kutztown, PA 19530, firstname.lastname@example.org, TINDALL, Sarah E., Department of Physical Sciences, Kutztown University, P.O. Box 730, Kutztown, PA 19530, and SIMPSON, Edward L., Physical Sciences, Kutztown University of Pennsylvania, 424 Boehm, Kutztown, PA 19530|
Debate about the existence of reactivated basement faults underlying some or all Colorado Plateau monoclines has raised questions about the effects of basement fault geometry, slip gradient, and segmentation on monocline surface expressions. Physical analog models are being conducted to study the relationships among basement fault segmentation, monoclinal folding, and surface strain patterns. The basic model design involves a stiff plastic sheet containing pre-cut fault segments overlain by alternating colored layers of dry sand. The plastic ‘basement' sheet and the sand overburden are shortened at 6.0 cm/hr by a motor-driven moveable wall, causing the plastic sheet to both flex and fault along the pre-existing cuts, resulting in deformation of the overlying sand layers. Variations among experiments involve the lengths and orientations of pre-cut fault segments, and the strike-parallel and strike-perpendicular step-over distances between fault segments. Following deformation, models are moistened and sliced to inspect fault and fold patterns within the sand overburden.
Model results show that stepped basement fault segments create bends in the surface expressions of monoclines. In most models conjugate normal faults form along the crests of monoclines, developing earlier and showing greater displacement above lateral basement fault steps than above the centers of basement fault segments. Deformation of surface markers is consistent with increased extensional strain accommodation in step-over regions of the models. Cross sectional slices reveal thrust faults propagating from both the hanging wall and footwall tips of the basement faults. Surprisingly, some models display the greatest vertical offset and the largest amplitude of monoclinal folding near the tips of basement faults while others experience maximum displacement and fold growth at the middle of each segment.
The normal faults observed above basement fault steps in the physical models resemble a pattern of faulting associated with eastward bends in the generally northerly trace of the East Kaibab monocline of southern Utah. Further physical modeling and field studies of monoclines may help identify specific links between surface fold and fault patterns and underlying basement fault characteristics.
Rocky Mountain Section - 59th Annual Meeting (7–9 May 2007)
General Information for this Meeting
|Session No. 16--Booth# 12|
Structural Geology, Tectonics, Geophysics, and Geoscience Information (Posters)
Dixie Center: Ballroom C/D
8:00 AM-12:00 PM, Tuesday, 8 May 2007
Geological Society of America Abstracts with Programs, Vol. 39, No. 5, p. 37
© Copyright 2007 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.